Kata T4 Update

Home Updates and Firmware Kata update Kata T4 Update

How to update Kata T4?

To update the Kata T4 you need to install an alternate firmware (ROM). If the device does not automatically update by itselves.

You can use the new firmware for your smartphone.

You have to choose the firmware version and follow the instructions. If you have a trouble in update you can write about it in the comments below, we’ll help you.

Kata T4 update:

Kata T4 update – official firmware (OS 4.4.2)

If you are looking for another firmware, you can write a comment below. We will solve your problem and give you a link to update the firmware.

Kata update

There are three ways Kata update:

Using recovery (to update installed OS)
Using Research Download (to recover Kata with Spreadtrum SOC)
Using SP Flash Tool (to recover Kata with MTK SOC)

If you want to install a Kata update using recovery – download the official update, reboot your phone or tablet into recovery mode and click “Install update from SD card”.

Kata update

If your model is not listed, you can write a comment below. We will solve the problem and give you a link to update the firmware.

Show more Kata updates

Show less

SP Flash Tool download and use

SP Flash Tool download and use guide will help you flash Android smartphone with MTK SOC. First of all, make sure that you have the MTK based smartphone, after this continue read SP Flash Tool Android update guide.

Download and unpack the program. SP Flash Tool Android update required the PC with installed MTK drivers, you can download it here and install by this guide:

Unpack the drivers archive
Run “DriverInstall.exe”

Follow the instalator instructions
Reboot your PC

After installing MTK drivers, download SP Flash Tool Android firmware for your smartphone or tablet here

If your model is not present, you can write a comment below. We’ll solve a problem and give a link for update firmware.

Unpack the SP Flash Tool Android upgrade for your phone and follow the instruction SP Flash Tool how to use:

Run SP Flash Tool
Click “Choose” on the “Scatter-loading” line and select scatter file from downloaded firmware

Go to “Options” and enable “DA DL All with Checksum” in download section

Close settings
Choose “Firmware update” for update your phone or “Download” to flash any part of the firmware
Click “Download”

Turn off your phone or tablet and connect it to the PC with USB cable, if drivers installed successfully – flashing will start, if flash won’t start – reinstall drivers
After everything is done, you will receive an “OK” window, close it, disconnect your phone and press Power On key

Done! SP Flash Tool download and use is very simple for users. If you receive some errors – write it in the comments below and I’ll help you to recover your phone.

0 0