How to update Huawei Honor 3C?
To update the Huawei Honor 3C you need to install an alternate firmware (ROM). If the device does not automatically update by itselves. You can use the new firmware for your smartphone.
You have to choose the firmware version and follow the instructions. If you have a trouble in update you can write about it in the comments below, we’ll help you.
Huawei Honor 3C Update:
Huawei Honor 3C Lite Update:
- Huawei Honor 3C Lite update – official firmware (OS 4.4 (B115))
Huawei update
There are three ways Huawei update:
- Using recovery
- Using eRecovery
- Using SP Flash Tool (to recover Huawei with MTK SOC)
First of all – download a file for your model from the list below, save it to SD card or internal storage.
To run recovery mode for Huawei Android update:
- Power off your phone
- Press and hold volume up and power on buttons
- Choose “apply update from SD card”
- Wait until Huawei update will be installed.
Huawei Firmware
To flash Huawei firmware with erecovery mode follow the instruction:
- Download full Huawei firmware
- Unpack “dload” catalog into SD card
- Turn off your Huawei
- Press and hold both volume buttons and power on
- Phone will enter dload mode and automatically install Huawei update
SP Flash Tool download and use
SP Flash Tool download and use guide will help you flash Android smartphone with MTK SOC. First of all, make sure that you have the MTK based smartphone, after this continue read SP Flash Tool Android update guide.
Download and unpack the program. SP Flash Tool Android update required the PC with installed MTK drivers, you can download it here and install by this guide:
- Unpack the drivers archive
- Run “DriverInstall.exe”
- Follow the instalator instructions
- Reboot your PC
After installing MTK drivers, download SP Flash Tool Android firmware for your smartphone or tablet here
Unpack the SP Flash Tool Android upgrade for your phone and follow the instruction SP Flash Tool how to use:
- Run SP Flash Tool
- Click “Choose” on the “Scatter-loading” line and select scatter file from downloaded firmware
- Go to “Options” and enable “DA DL All with Checksum” in download section
- Close settings
- Choose “Firmware update” for update your phone or “Download” to flash any part of the firmware
- Click “Download”
- Turn off your phone or tablet and connect it to the PC with USB cable, if drivers installed successfully – flashing will start, if flash won’t start – reinstall drivers
- After everything is done, you will receive an “OK” window, close it, disconnect your phone and press Power On key
Done! SP Flash Tool download and use is very simple for users. If you receive some errors – write it in the comments below and I’ll help you to recover your phone.
Read more
